Skip to main content
Building from source requires that the Rust toolchain is installed, as well as the just command runner.Visit the Prerequisites for details on installing Rust and just.
First clone the repository:
Then, install the kona-node binary into your PATH directly via:
The binary will now be accessible as kona-node via the command line, and exist under your default .cargo/bin folder. Alternatively, you can build yourself with:
This will place the reth binary under ./target/release/kona-node, and you can copy it to your directory of preference after that.

​
Update Kona

You can update the kona-node to a specific version by running the commands below. ${VERSION} is the version you wish to build in the format vX.X.X.

​
Troubleshooting

​
Command is not found

Reth will be installed to CARGO_HOME or $HOME/.cargo. This directory needs to be on your PATH before you can run the kona-node binary. See “Configuring the PATH environment variable” for more information.

​
Compilation error

Make sure you are running the latest version of Rust. If you have installed Rust using rustup, simply run rustup update. If you can’t install the latest version of Rust you can instead compile using the Minimum Supported Rust Version (MSRV) which is listed under the rust-version key in kona’s Cargo.toml. If compilation fails with (signal: 9, SIGKILL: kill), this could mean your machine ran out of memory during compilation. If you are on Docker, consider increasing the memory of the container, or use a pre-built binary. If compilation fails with error: linking with cc failed: exit code: 1, try running cargo clean.

​
Next Steps